6-4 After Data acquisition（Data acquisition）
・ When [Meas Time] is other than
＊＊＊
not receiving the
Ｅ
command
： Data acquisition completed command
ｒ
is issued to CPU.
・
In Interval/Repeat mode,
ｒ
is issued every time of the measurement
・
On
Ｅ
command issued, the measurement is terminated even in the Repeat mode.
6226 PC
Data acquisition
completed command
ｒ
Data Request command
Ｄ
Data Transfer
< Data format＞
００／０１／０５□０２：１５:１６□Ｆ□１３０ｄＢ+LF
００ｈ００ｍ００ｓ+LF
Ｌａｅｑ：□１３０．０□□□Ｌａ０５：□１３０．０+LF
Ｌａｅ□：□１３０．０□□□Ｌａ１０：□１３０．０+LF
□□□□□□□□□□□□□□Ｌａ５０：□１３０．０+LF
ＬＭｉｎ：□１３０．０□□□Ｌａ９０：□１３０．０+LF
ＬＭａｘ：□１３０．０□□□Ｌａ１０：□１３０．０LF +LF
□ ：Space （２０）
+LF：Code linefeed（０Ａ）
6-5 Lp-value acquisition
6226 PC
<Data format > (5Byte + CR )
130.0 + CR
6-6 Notes
・Flow control is not available in 6226.
・For communication command error, the
？
mark is returned.
・To return to Calibration, Stop measurement command
Ｅ
is used.
P ：Lp acquisition
Data transfer
Data
Data
To Next Page
