6. SPECIFICATIONS
6.1. Parameters
a) Frequency Coverage
• All amateur bands in the 1.8-29.7 MHz frequency range;
• Extensions and/or changes on request;
b) Power Output
• 700 W PEP or 500 W continuous carrier;
c) Intermodulation Distortion
• Better than 35 dB below rated output;
d) Hum and Noise
• Better than 40 dB below rated output;
e) Harmonic Output Suppression
• Better than 50 dB below rated output;
f) Input and Output Impedance
• Nominal value: 50 Ohm unbalanced, UHF (SO-239) type connectors;
• Input circuit: broadband, SWR less than 1.3:1, 1.8-30 MHz continuously (no tuning, no
switching);
• Bypass path: SWR less than 1.1:1, 1.8-30 MHz continuously, 200 W maximum;
• Output (antenna) impedance matching capability: SWR up to 3:1 or higher;
g) RF Gain
• 11 dB typically, frequency response less than 1 dB (50-70 W drive power for rated
output);
h) Mains Power Supply Voltage
• 85-132 VAC / 170-264 VAC (100, 110, 120, 200, 210, 220, 230 & 240 V nominal taps,
+10% -15% tolerance), 50-60 Hz, Single phase;
i) Mains Power Consumption
• 1200 VA at rated output;
j) Safety and Electromagnetic Compatibility
• Complies with CE safety and electromagnetic compatibility requirements, as well as with
the US Federal Communications Commission (FCC) regulations;
k) Size & Weight (operating, excluding connected cables)
• WxDxH: 402x315x166 mm, 17 kg (15.9x12.4x6.6 inches, 37.5 lbs.);
To Next Page
