Acom 1010 User Manual

User's Manual | ACOM 1010 | HF Linear Amplifier
July 2021
S e c t i o n GENERAL INFORMATION | Page
7
of
40
1. GENERAL INFORMATION
Congratulations on purchasing one of the finest HF amplifiers in the world today.
ACOM is pleased that you have chosen one of our products, and we will endeavor to provide you with the
information and support you need to enjoy your purchase for many years.
We urge you to read all of the following materials before you embark on operating your new amplifier.
1.1. Introduction and Description
This manual explains:
• Installation
• Operation and
• Maintenance
of the ACOM 1010 HF linear amplifier.
The ACOM 1010 is a self-contained linear amplifier that covers all amateur bands, from 1.8 through
29.7 MHz. It provides over 700 W PEP of output power (or 500 W in continuous-duty operation) with less
than 60 W of drive. The amplifier is designed to tolerate SWR levels of up to 3:1 throughout its operating
range, and tuning is simplified by ACOM's exclusive True Resistance Indicator (TRI). Also, a built-in antenna
selector switch with two outputs is included to provide instant choice of antennas. Importantly, a variety of
system parameters are continuously monitored and available to the operator to assure safe and efficient
amplifier operation.

Acom 1010 Specifications

General

Complies with CE safety and electromagnetic compatibility requirements, as well as FCC regulations	Yes
Power Output	1000 W PEP
Modes	SSB, CW, RTTY, AM, FM
Power Supply	200-240VAC or 100-120VAC, 50-60Hz, single phase.
Cooling	Forced air
Harmonic Output	-50 dB
Input Impedance	50 Ohms
Output Impedance	50 Ohms
Tube	4CX800A