EasyManuals Logo

Acom 1010 User Manual

Acom 1010
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
User's Manual | ACOM 1010 | HF Linear Amplifier
Page
10
of
40
| S e c t i o n GENERAL INFORMATION
July 2021
1.5. Safety Considerations, Explicit Definitions
The ACOM 1010 HF Linear Amplifier is a Safety Class I unit regarding protection against electric shock. The
third grounding lead of its mains cord (which is colored yellow with two green stripes) and the ground stud
on the rear panel of the amplifier (marked GND, see ) must be connected to the station's grounding system
for safe operation.
The amplifier is designed to meet international safety standards and complies with CE safety and
electromagnetic compatibility requirements, as well as FCC regulations.
This User's Manual contains information, warnings (signal words Danger, Warning, Caution and Notice) and
instructions, related to hazards, that should be followed by the user in order to ensure safe operation and
to keep the amplifier in a safe working condition at all times.
The EXPLICIT DEFINITIONS described below apply to this User's Manual:
DANGER
These notes call attention to a procedure or instructions which, if not correctly
performed, will result in serious personal injuries and even death.
WARNING
These notes call attention to a procedure or instructions which, if not correctly
performed, could result in serious personal injuries and even death.
CAUTION
These notes call attention to a procedure or instructions which, if not correctly
performed, could result in minor or moderate personal injuries.
NOTICE
These notes call attention to a procedure or instructions which, if not correctly
performed, could result in property damage or equipment damage not exclusively to
the amplifier but also to connected equipment.

Other manuals for Acom 1010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Acom 1010 and is the answer not in the manual?

Acom 1010 Specifications

General IconGeneral
Complies with CE safety and electromagnetic compatibility requirements, as well as FCC regulationsYes
Power Output1000 W PEP
ModesSSB, CW, RTTY, AM, FM
Power Supply200-240VAC or 100-120VAC, 50-60Hz, single phase.
CoolingForced air
Harmonic Output-50 dB
Input Impedance50 Ohms
Output Impedance50 Ohms
Tube4CX800A

Related product manuals