Acrosser Technology AR-V6002FL - Default Chapter; Table of Contents

To Next Page

To Previous Page

Revision: 1.23

Table of Contents

System Installation Guide..................................................5

1 Introduction to AR-V6002FL.....................................................6

1.1 Specifications................................................................................... 6

1.2 Packing List ..................................................................................... 7

1.3 System Dissection........................................................................... 8

2 Procedures of Assembly/Disassembly.................................13

2.1 DDR3 Memory Installation............................................................. 13

2.2 HDD Installation............................................................................. 15

2.3 SIM Card Installation ..................................................................... 18

2.4 CF Card Installation....................................................................... 20

2.5 RF Antenna Installation.................................................................. 22

Board Guide ......................................................................23

1 Introduction.............................................................................24

1.1 Specifications................................................................................. 24

2 H/W Information ......................................................................25

2.1 Locations of Connector and Jumper Setting..................................... 25

2.2 Connector and Jumper Setting Table................................................ 28

2.3 Power Subsystem............................................................................. 33

2.4 Remote Switch.................................................................................. 36

2.5 Status LED........................................................................................ 36

2.6 Fuse selection................................................................................... 36

2.7 COM1 / 2 to choose RS-232 / RS-485 / RS-422 by Jump setting .... 37

2.8 GPIO................................................................................................. 37

3 BIos setting..............................................................................38

3.1 Main Setup........................................................................................ 39

3.2 Advanced Chipset Setup................................................................... 41

3.3 Power Setup ..................................................................................... 43