Hardware Manual
16
8. Once the cable length is determined, seal the bottom cable hole with silicon to protect it from
water leak.
9. Mount the camera on the surface using the bundled screws with o-rings.
CAUTION: When using electric screwdrivers, be careful not to touch the internal camera
components while attaching the screws. Since electric screwdrivers vary in sizes, speed, and
force, they may bruise and damage the internal camera components.
DISCLAIMER: ACTi will not be responsible for camera damage caused by improper
installations or the misuse of equipment for installation.
10. Connect the Ethernet cable to the Ethernet port of the camera.
To Next Page
Loading...
