Step 3.Assign a number for the current position from the drop-down Number
List (click <PrePage> or <NextPage> button to reach number 1 to 256),
and enter its descriptive name.
Step 4.Click the <Set> button to save the settings.
Preset Go
To have the camera move to a specified preset position, please select the
Preset
Point
from
the
drop
-down
Preset
list
(click
<PrePage>
or
<NextPage>
button to reach preset number 1 to 256). Then the camera shall move to the
target position.
2.6.2 Cruise
The Cruise Programming can be found under this path: PTZ> Cruise.
The camera supports up to 8 Cruise Paths. Please follow the instructions below
for Cruise Path setup.
Cruise Setting
Refer to the steps below to setup a Cruise Path.
Step 1.Select a path number from the drop-down list.
Step 2.Move the cursor to the live view pane, and move the camera to a desired
view (PTZ controls) as the start point of a Cruise Path.
Step 3.Click the <Set> button of <Record Start> and start programming the
Cruise Path via PTZ controls.
Step 4.When finishing programming, click the <Set> button of <Record End> to
complete recording the Cruise Path.
Cruise Run
Select the specified Cruise Path from the drop-down list, click the <Run> button,
and then the camera will start touring around as recorded.
To view the camera touring in full screen mode, please move the cursor onto the
live view pane, right-click and left-click to select “Fullscreen”. Then users can
view the camera navigation in full screen.
To stop running a Cruise Path, simply move the cursor to the live view pane and
move the camera in any direction.
To Next Page
Loading...
