ACTi A950 - Events (Alarm Settings)

34
2.2.8 Events (Alarm Settings)
The Events setting can be found under this path: System> Events.
Click on <Events>, there will be a drop-down menu with tabs including
<Application>, <Motion Detection>, <Network Failure Detection>, <Tampering>,
<Periodical Event>, <Manual Trigger>, and <Audio Detection>.
2.2.8.1 Application
The Application setting can be found under this path: System> Events>
Application.
The camera supports one alarm input and one relay output for cooperation with
alarm system to catch event images. Refer to alarm pin definition below to
connect alarm devices to the camera if needed.
Alarm Switch
The default setting for the Alarm Switch function is <Off>. Enable the function by
selecting <On>. Users can also activate the function according to the schedule
previously set in the <Schedule> setting page. Select <By schedule> and click
<Please select…> to choose the desired schedule from the drop-down menu.
Alarm Type
Select an alarm type, <Normal close> or <Normal open>, that corresponds with
the alarm application.
Triggered Action
The administrator can specify alarm actions that will take when the alarm is
triggered. All options are listed as follows.
 Enable Alarm Output (high/low)
Select the item to enable alarm relay output.
 IR Cut Filter
Select the item and the IR cut filter (ICR) of the camera will be removed
(on) or blocked (off) when alarm input is triggered. This function is only
available for models with IR cut filter.
NOTE: The IR Function (refer to section IR Function) could not
be set as <Auto> mode if this triggered action is enabled.