2.3.6 Video OCX Protocol
The Video OCX Protocol setting can be found under this path: Streaming>
Video OCX Protocol.
In the <Video OCX protocol> setting page, the administrator can select RTP
over UDP, RTP over RTSP(TCP), RTSP over HTTP or MJPEG over HTTP, for
streaming media over the network. In the case of multicast networking, users
can select the Multicast mode. Click on <Save> to confirm the setting.
Video OCX protocol setting options include:
RTP over UDP / RTP over RTSP(TCP) / RTSP over HTTP / MJPEG
over HTTP
Multicast Mode
Enter all required data, including <Multicast Stream 1~4 Video Address/
Multicast Stream Audio Address>, <Multicast Port> and <Multicast TTL>
into each blank.
Click on <Save> to confirm the setting.
2.3.7 Video Mask
The Video Mask setting can be found under this path: Streaming> Video Mask.
Active Mask Function
Add a Mask
Check a Video Mask checkbox, and a red frame will come out in the Live
Video pane. Use the mouse to drag and drop to adjust the mask’s size
and place it on the target zone. At most 5 video masks can be set.
NOTE: It is suggested to set the Video Mask slightly bigger than
the object.
Cancel a Mask
Un-check the Video Mask checkbox meant to be deleted; the mask will
disappear from the Live Video pane instantly.
Mask Setting
Mask color
The selections of Mask color include black, white, yellow, red, green,
blue, cyan, and magenta. Click on <Save> to confirm the setting.
To Next Page
Loading...
