EasyManua.ls Logo

ACTi A950 - Page 48

ACTi A950
116 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
47
Upload Image by FTP
Select this item and the administrator can assign an FTP site and
configure various parameters. When tampering is detected, event
images will be uploaded to the appointed FTP site. Note that to
implement this function, one of the streaming MUST be set as MJPEG;
otherwise, this function will be grayed out and cannot be accessed.
<Pre-trigger buffer> function allows users to check what caused the
trigger. The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after tampering is triggered.
NOTE: <Pre-trigger buffer> generally ranges from 1 to 20 frames.
However, the range will change accordingly if the frame rate of
MJPEG on Streaming> Video Configuration is 6 or smaller.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __ sec> and enter the duration in the blank. The images of
the duration will be uploaded to FTP when tampering is triggered. The
setting range is from 1 to 99999 sec. Select <Upload during the trigger
active> to make the images keep being upload to FTP during the trigger
active until the tampering stops. Set the Image frequency as the upload
frame rate. The setting range is from 1 to 15 frames.
NOTE: Make sure FTP configuration has been completed. Refer
to section FTP for further details.
Upload Image by E-Mail
Select this item and the administrator can assign an E-mail address and
configure various parameters. When tampering is detected, event
images will be sent to the appointed E-mail address. Note that to
implement this function, one of the streaming MUST be set as MJPEG;
otherwise, this function will be grayed out and cannot be accessed.
<Pre-trigger buffer> function allows users to check what caused the
trigger. The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after tampering occurs.

Other manuals for ACTi A950

Related product manuals