ACTi A950 - Page 52

51
 Upload Image by E-mail
Select this item and the administrator can assign an E-mail address and
configure various parameters. Images will be uploaded to the appointed
E-mail address periodically. Note that to implement this function, one of
the streaming MUST be set as MJPEG; otherwise, this function will be
grayed out and cannot be accessed.
The <Pre-trigger buffer> function can define how many images to be
uploaded before the triggered moment. The <Post-trigger buffer>
function can define how many images to be uploaded after the triggered
moment.
NOTE: <Pre-trigger buffer> generally ranges from 1 to 20 frames.
However, the range will change accordingly if the frame rate of
MJPEG on Streaming> Video Configuration is 6 or smaller.
NOTE: Make sure SMTP configuration has been completed.
Refer to section Mail of this chapter for further details.
 Upload Image to SD Card
Select this item, and then the images will be uploaded to the SD card
periodically. Note that to implement this function, one of the streaming
MUST be set as MJPEG; otherwise, this function will be grayed out and
cannot be accessed.
The <Pre-trigger buffer> function can define how many images to be
uploaded before the triggered moment. The <Post-trigger buffer>
function can define how many images to be uploaded after the triggered
moment.
NOTE: <Pre-trigger buffer> generally ranges from 1 to 20 frames.
However, the range will change accordingly if the frame rate of
MJPEG on Streaming> Video Configuration is 6 or smaller.
NOTE: Before implementing <Upload Image to SD Card>,
please make sure that the SD Card is properly detected and
installed. Refer to Storage Management> SD Card> Device
Information for further details.