33
Chapter 5 Configuring Advanced Settings
We strongly recommend leaving the $(#0 Server option On. If the $(#0 Server
option is Off, ensure the IP addresses of the networked computers are on the same
subnet as the IPADDRESSOFTHE'ATEWAY&ORMOREINFORMATIONSEEh$(#0 Server
#ONFIGURATIONv
DHCP Server Configuration
#LICKINGINTHECHECKBOXLABELEDh)WOULDLIKETOADJUSTTHE$(#0SERVERSETTINGSv
activates the text boxes at the bottom of the $(#03ETTINGSSCREEN#HANGETHEIP
address range and DNS server information in these text boxes.
Beginning IP Address
This is the IP address at which the $(#0server starts assigning IP addresses. We
recommend keeping the factory default setting (192.168.1.64).
Ending IP Address
This is the IP address at which the $(#0server stops assigning IP addresses. We
recommend keeping the factory default settings (192.168.1.254).
The beginning and ending IP addresses define the IP address range of the
Gateway. If the default values are left intact, the Gateway supplies a unique IP
address between 192.168.1.64 and 192.168.1.254 to each computer on the net-
work. Note that the first three groups of numbers of the addresses are identical;
this means they are on the same subnet. The IP address of the Gateway must
be on the same subnet as the IPADDRESSRANGEITGENERATES&ORINSTANCEIFTHE
Gateway’s IP address is changed to .222.1, set the beginning IP address to
, and the ending IP address to .
Subnet Mask
Enter the IP address of the $(#0server’s subnet mask here.
Lease Time
This value represents the amount of time (in seconds) the $(#0server holds
onto a specific IP address.
To Next Page
Loading...
Need help?
General
