ActionTec PK-5000 - Remote Management; Telnet Timeout Setting

42
Wireless DSL Gateway User Manual
Remote Management
To access the Gateway from the Internet, activate Remote Management by select-
ing the appropriate On radio button and writing down the 7!.IP address of the
Gateway (see “7!.)0!DDRESSv/NACOMPUTEROUTSIDEOFTHENETWORKOPENA
Web browser and enter the Gateway’s 7!.)0 address in the address text box. The
Gateway’s Home screen (or a password prompt, if a password has been set) appears
in the browser window.
Telnet
4OACCESSTHE'ATEWAYVIA4ELNETACTIVATE4ELNETBYSELECTINGTHEAPPROPRIATEh/Nv
radio button and writing down the 7!.)0address of the Gateway (see “7!.)0
!DDRESSv/NACOMPUTEROUTSIDETHENETWORKRUNNINGA4ELNETPROGRAMENTERTHE
Gateway’s 7!.)0address to access the Gateway.
!
Note: Before remote management or Telnet can be activated, the
administrator password must be set. To do this, go to the Home
screen, click Security, then select Admin User Name and
Password&OLLOWTHEINSTRUCTIONSINTHESUBSEQUENTSCREENS
When finished in this screen, click Apply to activate any changes made.
Telnet Timeout Setting
Selecting Telnet Timeout SettingINTHEh!DVANCED3ETUPvSCREENGENERATESTHE
h4ELNET4IMEOUT3ETTINGvSCREEN3ELECTAPERIODOFTIMEFROMTHECHOICESAVAILABLE
and the Telnet session will automatically terminate at that time. If no automatic
TERMINATIONISNEEDEDSELECTh.OIDLEDISCONNECTTIMEOUTv
When finished in this screen, click Apply to activate any changes made.