ActionTec PK-5000 - Page 40

39
Chapter 5 Configuring Advanced Settings
Total Available Bandwidth
Displays the total amount of available bandwidth (in kilobits per second).
High Priority Bandwidth
Enter the amount of high priority bandwidth to be used by the prioritized
traffic type (cannot exceed total available bandwidth).
Priority
!LWAYSSETTOh(IGHvANDCANNOTBECHANGED
Protocol
Select the data type being configured. Options: 4#0, UDP, )#-0.
Source
Identify the source device here, using the device’s IP or -!#address, then enter
appropriate value in text box. If IP is used, enter the netmask address, if applicable.
!PRIORITYPORTRANGECANALSOBEDEFINEDUSINGTHEh0ORT2ANGEvTEXTBOXES
Destination
Identify the destination device here, using the device’s IP address, then enter appro-
PRIATEVALUEINTEXTBOX%NTERTHENETMASKADDRESSIFAPPLICABLE!PRIORITYPORT
RANGECANALSOBEDEFINEDUSINGTHEh0ORT2ANGEvTEXTBOXES
Rule List
!FTERFINISHINGTHECONFIGURATIONOFTHE1O3SETTINGSCLICKAdd to save the settings
in the Rule List menu box. This collection of QoS settings can then be reused at a
future time. If deleting a QoS rule list, highlight it, then click Remove.
When finished in this screen, click Apply to activate any changes made.