ActionTec PK-5000 User Manual

5
Chapter 1 Introduction
Reset Switch
Depressing the Reset switch for one second will restore the Gateway’s factory
default settings. To reset the Gateway, depress and hold the Reset switch for
approximately ten seconds. The reset process will start after releasing the switch.
USB Port
The USB port is used to connect a computer to the Gateway via USB cable.
Power Port
The Power port is used to connect the Power cord to the Gateway.
!
Warning: Do not unplug the Power cord from the Gateway
during the reset process. Doing so may result in permanent
damage to the Gateway.
Power Switch
The Power switch is used to power the Gateway on and off.

ActionTec PK-5000 Specifications

General

Brand	ActionTec
Model	PK-5000
Category	Gateway
Language	English