EasyManuals Logo

ActionTec ScreenBeam 960 Deployment Guide

ActionTec ScreenBeam 960
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
© 2018 Actiontec Electronics Inc. All rights reserved. ScreenBeam Deployment Guide
3. If the PIN option is enabled on the ScreenBeam, another dialog box will appear
asking for the PIN as follows:
Enter the corresponding PIN and tap Ok.
4. The iOS device should now be mirroring to the front-of-room display.
5. To disconnect the iOS device from the front-of-room display, swipe upward from the
bottom of the iOS device screen, or inward from the top-right corner on newer
versions of iOS, to bring up the Control Center. Tap on Screen Mirroring, then tap
on Stop Mirroring.

Other manuals for ActionTec ScreenBeam 960

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ActionTec ScreenBeam 960 and is the answer not in the manual?

ActionTec ScreenBeam 960 Specifications

General IconGeneral
BrandActionTec
ModelScreenBeam 960
CategoryReceiver
LanguageEnglish

Related product manuals