28
© 2018 Actiontec Electronics Inc. All rights reserved. ScreenBeam Deployment Guide
Part IX Connecting to Receiver
The following outlines procedures for connecting devices wirelessly to the display over LAN
using the ScreenBeam receiver.
9.1 macOS
For macOS devices, follow the connection procedure below:
1. Ensure that Wi-Fi on the source device is turned on.
2. Confirm that the source device and the ScreenBeam receiver are connected to the
same LAN.
3. Start the ScreenBeam Wireless Display application. The application starts and scans
for ScreenBeam receivers:
4. The application then discovers ScreenBeam receivers on the same LAN and displays
them in the list:
To Next Page
Loading...
Need help?
General
