ActionTec ScreenBeam 960 - D. Configure ScreenBeam Receiver; Using ScreenBeam CMS Software; Using Local Management on ScreenBeam

5
© 2018 Actiontec Electronics Inc. All rights reserved. ScreenBeam Deployment Guide
1.2 System Requirements for Display Devices
The minimum system requirements of devices used to connect to ScreenBeam 960 with
firmware 9.15.39.0 (or later) are:
• OS: MS Windows 7 with SP2 or later, macOS 10.10 or later, and Android 4.2 or later
with Miracast
• CPU: 4th Gen Intel Core i3 or AMD equivalent
• Wi-Fi: 802.11n or 802.11ac Dual-Band 2x2
• RAM: 4GB
• HDD free space: 50GB
The recommended system requirements of devices used to connect to ScreenBeam 960
with firmware 9.15.39.0 (or later) are:
• OS: MS Windows 8.1 or later, or 2012 and later Macs running macOS 10.10 or later
• CPU: 5th Gen Intel Core i5 or AMD equivalent, or later
• Wi-Fi: Intel Dual-Band Wireless AC 726x (or later)
• RAM: 8GB
• HDD free space: 50GB (or more)
1.3 ScreenBeam Network Requirements
The minimum network requirements for ScreenBeam 960 Ethernet connection for Wireless
Display over LAN are:
• IEEE 802.3u / 100BASE-TX compliant 100Mbps Ethernet connection for ScreenBeam
receiver connection
Note: IEEE 802.3ab / 1000BASE-T 1Gbps Ethernet connection is recommended
• RJ-45-terminated shielded Cat 5e or better Ethernet cable from switch to ScreenBeam
receiver
• 802.11n/ac Wi-Fi connectivity for client devices (5GHz strongly recommended)
• Network ports:
o macOS: 8554 (TCP), 24030 (UDP), 35507 (TCP)
o macOS native mirroring: 5353 (UDP), 7000 (UDP), 7100 (TCP), 47000 (TCP),
32768 to 60000 (UDP)
o Win 7: 7236 (TCP), 24030 (UDP), 35507 (TCP)
Note: VLAN routing may be required if ScreenBeam and Client devices are connected to
different VLAN networks.