Actron CP9680 - 5.3 Erase Codes

en
|
28
|
User guide
| CP9680
AutoScanner® Plus
573102 | REV. A | 07.2015
Bosch Automotive Service Solutions Inc.
EGR Position High
MIL CODE 213
1/1
Eng
-----
Active is a DTC that was present at the time of scan tool
request.
Intake Air Temperature Sensor
1 Circuit High
ACTIVE
1/1
Eng
P0113
4. Return to Diagnostic Codes Menu.
• Press .
5.3 Erase Codes
The Erase Codes function deletes DTCs and resets I/M
Monitor data from vehicle’s control module(s). Perform
this function key on engine off (KOEO). Do not start the
engine.
The Erase Codes function may also erase View Freeze
Data, O2 Monitor Tests, and Diagnostic Monitor Test
results depending on vehicle.
The Erase Codes function sets monitors to inc.
Perform Erase Codes function only after systems have been
checked completely and DTCs have been written down.
After servicing the vehicle, erase stored DTCs and verify
no codes have returned. If a DTC returns, problem has
not been fixed or other faults are present.
Permanent DTCs cannot be erased with the Erase Codes
function.
Depending on which monitor sets a code the vehicle
may need to be driven and the monitor ran before con-
cluding that the fault is repaired.
From Diagnostic Codes Menu:
1. Select Erase Codes.
• Use the UP and DOWN keys until Erase
Codes is highlighted.
• Press .
Diagnostic Codes
Read Codes
Erase Codes
View Freeze Data
Component Locator
Acronyms
Review Data
Print Data
Code Lookup
System Setup
• If diagnostic results and codes are not to be
erased select NO and press .
Erase Codes
Are you sure you want to
erase diagnostic results and
codes?
No
Yes
• Selecting NO displays a “Command canceled”
message.
Erase Codes
Press ENTER to continue
Command canceled
2. Select YES to erase diagnostic results and codes.
• Use the LEFT arrow key.
• Press .
Erase Codes
Are you sure you want to
erase diagnostic results and
codes?
No
Yes
3. If more than one module is supported, a menu is
displayed.
• Use the UP and DOWN keys until the
desired choice is highlighted.
• Press .