5.6 AUTOMATIC MEMORY ACCUMULATION
• The indicator can also be set to store the weight values in
memory automatically as above accumulation control setting.
Ensure it has been enabled (see section 8.0).
• To check the total accumulation, press the [Kg/lb /Set] key. If
the memory already has values stored in it the display will
show how many entries have been stored. i.e. “n 5”,
followed by the total stored value, this value will scroll across
the display if it is too large to fit the display digits (> 999999).
• If the memory has previously been cleared it will show “n 0”
followed by zero weight.
• If you wish to clear the memory press the [Kg/lb /Set] to view
totals then [Zero] when the totals are being displayed key.
5.7 ACCUMULATION VALUE DISPLAY, PRINT AND CLEAR
• Press [Kg/lb /Set] key.
• The display will indicate the times of accumulation for
example; “n 52”, 2 seconds later display the accumulated
weight “23506.5” if in the weighing mode.
• If in count mode, it will display the times of accumulation, “n
52”, 2 seconds later the total number of count accumulated
will be displayed “12508”.
• When the number “n 52” is displayed and before the total is
shown, press the [Acc/] key, the accumulated value will be
printed if communication address is 99.
• When the number “n 52” is displayed and before the total is
shown, press [Zero] to clear the accumulated value.
To Next Page
Loading...
Need help?
General
