• Use the [Acc/] and [x10 /Inc] keys to input sample value.
This value will be stored for the next sample until power is
removed.
• Place a known quantity and press the [Kg/lb /Set] key. After
few seconds, the count will be displayed.
• If at –SanP- the sample value is not set and the [Kg/lb /Set] is
pressed directly, the value shown will be based on the sample
value set previously.
• Press the [On/off] key to enter weighing mode and the Count
indicator will be switched off.
5.11 HIGH RESOLUTION DISPLAY
This operation is available only if the function is enabled as explained in
section 8.0.
In weighing mode, press the [x10 /Inc] to enter high resolution display (10
times) and the right most decimal point will be lit.
Press the [x10 /Inc] key again to return to the normal weighing display.
To Next Page
Loading...
Need help?
General
