8.0 USER PARAMETERS
Switch the power to off. Press and hold [Acc /] and switch on the
power again. The factory parameters will be skipped and user function
parameters will be displayed for setting.
Please see the full AE 202 User manual for access to factory parameters.
Switch the power to off. Press and hold [Acc /] and switch on the
power again. The factory parameters will be skipped and user function
parameters will be displayed for setting.
• If you enter this section, the user functions will be displayed in the
format “F - AbCdE” The related functions are listed below.
• Press [Acc /]. The first digit will start flashing.
• Press the [x10 /Inc] key to change the options. (0 or 1).
• Press [Acc /] to move to the next digit.
• Once all the values are entered, press [Kg/lb /Set] to move to the
next parameter for setting the filter.
: No auto power off function
A = 1: With auto power off function (If the weighing value does not
change in 15 minutes, the indicator will be turned power off)
b = 0: No unit switch to lbs
b = 1: With unit switch enabled
c = 0: No count function
c = 1: With count function enabled
d = 0: No accumulation function.
d = 1: With accumulation function enabled.
E = 0: No high resolution display function
E = 1: With high resolution X10 display function enabled.
To Next Page
Loading...
