Adaptec RAID 2100S - Command Line Switches

4-3
RAIDUTIL Command Line Utility
Command Line Switches
Following is a list of the switches available in RAIDUTIL for testing
and controlling various aspects of the controller, arrays, and drives
attached to the controller.
Type Switch Description
Miscellaneous -g Specify drive group
Logical Drive
Creation/Deletion
-c
-d
-D
-l
-s
-z
Specify controller ID (OS)
Specify controller ID (BIOS)
Delete logical drives
Specify new logical drive RAID level
Specify logical drive capacity
Specify logical drive stripe size
Array Modification -E
-f
Expand disk array
Force array state
RAID Operation -C
-r
-w
Load/save configuration
Specify task rate
Write caching
Controller-specific -a
-F
-X
-Z
Action (task) control
Update controller firmware, BIOS, or
NVRAM
Reset NVRAM configuration
Reset/clear embedded RAID
information
Hot Spare Control -h
-H
Create hot spare drive
Delete hot spare drive
General
Information
Display Parameters
-?
-A
-e
-I
-L
-P
-q
Display utility usage information
Alarm status and control
Display or delete event log messages
Display inquiry information
List devices
Paginate output
Quiet mode