Adaptec RAID 2100S - General Information and Feedback

4-10
RAIDUTIL Command Line Utility
General Information and Feedback
-? Display utility usage information
This option displays a summary of the command usage information.
This includes all command line switches and brief definitions.
-A Alarm status and control
When no parameters follow the switch, the alarm status and enable
flags are displayed, as follows:
-e Display or delete event log messages
This switch enables you to display or delete the entries in the
controller event log using the following parameters:
Examples:
RAIDUTIL -e soft -d0
Displays all log entries for controller 0.
RAIDUTIL -e delete d1
Deletes all event log entries on controller 1.
on Forces the audible alarm to sound
off Silences the audible alarm when it is on
enable Allow the alarm to be heard when a failure occurs
disable Prevents the alarm from sounding for any reason
soft Display all log data (Level 1)
recov Display only recoverable hard errors (Level 2)
nonrecov Display only nonrecoverable hard errors (Level 3)
status Display only status changes (Level 4)
delete Delete all log entries for the controller
d# The target controller ID for this command