4-7
RAIDUTIL Command Line Utility
RAID Operation
-C Load/save configuration
This switch has two options:
A file name must follow the load or save parameter. This is a .dsm
file, which can also be loaded or saved using Storage Manager.
-r Specify task rate
This switch sets a task priority for the device or logical drive. The
parameter can be 0 – 9; with 0 being the slowest and 9 being the
fastest. You can also specify the rate as follows:
The device address is required. Specify logical drives by their device
addresses. You can set the rate for all logical drives on a controller by
using the device address of the controller.
-w Write caching
Options are On and Off. The default (On) uses Write-Back caching.
Off sets the operation to Write-Through caching. Specify drives
using the device address.
load Loads the specified configuration file
save Saves the current configuration to the file name
specified
-r slow = 1
-r medslow = 3
-r med = 5
-r medfast = 7
-r fast = 9
To Next Page
Loading...
