A-4
SNMP
■ Host bus type
■ Max transfer rate
■ Controller modules (RAID, expansion, caching, DIMMs)
■ Adaptec Bus group is a list of the buses with a set of
parameters which describe and control a bus. These
parameters include:
■ SCSI/ATA bus number
■ SCSI bus width (ATA buses are always 16 bits wide)
■ SCSI/ATA bus type
■ SCSI/ATA bus transfer rate
■ Adaptec controller ID (on this bus)
■ Adaptec Device group is a list of devices managed by the
Adaptec subsystem and represents the physical configuration.
Each device in the system includes:
■ Device address information:
■ Controller
■ Bus
■ ID
■ LUN
■ Device Inquiry data
■ Device capacity and block size
■ Device RAID level and status (Optimal, Failed, etc.)
■ Adaptec Array group contains all the RAID-specific
information within the Adaptec subsystem. Each array
includes:
■ Configuration parameters
■ SCSI/ATA address information
■ Background task information
To Next Page
