ADE Accenta G3 User Manual

Intruder alarm system
Operating Instructions
Servicing organisation details
Servicing organisation (Installer) name: ____________________________________
Telephone number: _____________________________________________________
Date of installation: _____________________________________________________
Account number: _______________________________________________________
1
ZONES
Accenta
G3
mini
0123
5678
Chime Omit
Reset
4
9
Set
Prog
PA
Attack
Tamper
Day
1 2 3 4 5 6 7 8
Power
ZONE
24
56
7
8
3
0 1 2 3 4
5 6 7 8 9
CHIME OMIT
RESET
PROG
SET
PATA PowerDay
1
PA
New
remote
keypad

ADE Accenta G3 Specifications

General

Zones	8
Event Log	250 events
Keypads	Up to 4
Backup Battery	12V 2.1Ah
Outputs	programmable outputs
Compatible with	ADE accessories
Expandable Zones	Up to 16 zones with expanders

Summary

Operating Instructions

Personal Attack Activation

Details how to trigger a panic alarm by pressing specific keypad buttons.

How to Set the System

Ensure Premises Vacated

Before setting, ensure all occupants have left and doors/windows are closed.

Enter User Code and Exit

Input code, check zones are clear, and listen for the exit beep tone.

System Set Confirmation

How to Unset the System

Enter Premises and Listen

Enter by the recommended route and listen for the entry beep tone.

Key in User Code

Input your code to stop the entry tone; the Day indicator will light.

How to Part Set the System

Enter Code and Initiate

Select Part-Set Program

How to Silence an Alarm

Enter Code to Stop Alarm

Input your user code to silence the alarm sound.

How to Reset After An Alarm

Perform System Reset

Press the 'Reset' key to return the system to normal operation.

Check Reset Status

Anti-code Reset Procedure

How to Quick Set the System

Reduce Exit Time

How to Change Your User Code

Select User Code Reprogram

Enter New User Code

Key in the new 4-digit user code.

How to Change Your Second Code

Select Second Code Reprogram

Enter New Second Code

Key in the new 4-digit second user code.

How to Change the Duress Code

Enter Programming Mode

Press 'Prog' and enter main code; TA lights, Day goes out.

Select Duress Code Programming

Enter New Duress Code

Key in the new 4-digit duress code.

Exit Programming Mode

How to Test Your Alarm System

Enter Alarm Test Mode

Press 'Prog' and code, then '0' to select alarm test mode.

Test Strobe Light

Test External Siren

Test Internal Sounders

Walktest

Perform Walktest Procedure

Press '6' to walk around, triggering detectors and checking zones.

Stop Walktest