How to Unset the system
When you enter your premises you will need to unset (or turn off) the system.
1. Enter your premises by the route recommended
by your installer. The system will produce an
entry beep tone.
2.
Key in your code , and the
entry tone will stop. The green Day indicator
will light.
If any Zone, TA (Tamper) or PA (Attack)
indicator lights up then an alarm has occurred,
and an intrusion may have taken place. Seek
assistance before investigating further as
intruders may still be on the premises. Then
reset the system (refer to page 7).
Note that when you enter your premises you
will have a short period of time, usually
30 seconds, to key in your code. If you fail to do
this the system will go into alarm. Key in your
code to stop the alarm.
4
Operating instructions
Entry beep
To Next Page
Loading...
Need help?
General
