Walktest
Press to carry out a walktest. Walk around
your property, and in turn cause each of the
detectors to go into alarm. Also, open and
close all door and windows that are protected
by the system. For each detector (including
door or window sensor) that is activated the
system will produce a series of beeps, and the
associated zone indicator will light.
Press to stop this test.
"
IMPORTANT: Do not test any
“Personal Attack” buttons during the
walktest, since these are still active and
will cause a full alarm.
If any of the alarm tests fail, or you are unsure
of the correct procedure, contact your installer.
4.
Press to exit Alarm test and press
again to exit program mode. The TA
(Tamper) indicator will go out and the Day
indicator will light.
15
Accenta/Optima G3 intruder system
0
Reset Reset
ZONES
Attack
Tamper
Day
1 2 3 4 5 6 7 8
Power
Panel
ZONE
24
56
7
8
3
Remote Keypad
1
PATA PowerDay
6
To Next Page
Loading...
