How to part set the system
If your installer has programmed your system for part set operation you will be able to set some
zones of the system while others remain unset. Part set operation is often used at night time, and it
will permit you to freely walk around the bedrooms while the living area and outside doors are
protected. Your system may have 2 part-set programs called Program 2 and Program 3.
1. Before part-setting the system you should ensure that
all doors and windows are closed. Ensure that pets do
not have access to the protected areas. Your installer
may have instructed you to use a different keypad to
the one normally used to set the system.
The green Day indicator should be lit.
2.
Enter your code . The Exit beep
will start.
3.
Press the key. The exit tone will stop and Zone
indicators 1 to 3 will light.
4.
Press to select part-set program 2 or 3.
You must now leave the protected zones. The system
will set after a short time.
Note: There will be no exit beeps if
silent set exit mode was
programmed.
5
Accenta/Optima G3 intruder system
0 1 2 3
Exit beep
To Next Page
Loading...
Need help?
General
