ADE Accenta G3 User Manual

How to test your alarm system
You should check that your alarm system still works correctly by periodically carrying out the
alarm system tests described here.
How to test the Strobe, External Siren and Internal Sounders
1.
Press and enter your 4 digit user code
. The TA (Tamper)
indicator will light and the Day indicator will
go out to indicate that you are in Programming
mode.
2.
Press to select alarm test mode. The
Attack indicator lights to indicate that you are
in alarm test mode.
3.
Strobe test
Press to test the strobe light. This is
normally mounted on the external siren. It
should produce a bright flash at a rate of 1
flash every few seconds. Press to stop
this test.
Siren (Bell) Test
Press to test the external siren, this should
produce a loud alarm sound. Press to stop
this test.
Sounder Low Volume Test
Press to test the Low volume sounder.
This should produce a low volume alarm
sound. Press to stop this test.
Sounder High Volume Test
Press to test the High volume sounder.
This should produce a high volume alarm
sound. Press to stop this test.
14
Operating instructions
Prog
0 1 2 3
0
2
0
3
0
4
0
5
0
Strobe On
D
a
y
External siren
D
a
y
I
nterna
ll
ow vo
l
ume
sound
D
a
y
I
nterna
lhi
g
h
vo
l
ume
sound
D
a
y
ZONES
Attack
Tamper
Day
1
2
3
4
5
6
7
8
Power
Panel
ZONE
24
56
7
8
3
Remote Keypad
1
PATA PowerDay
ZONES
Attack
Tamper
Day
12345678
Power
Panel
ZONE
24
56
7
8
3
Remote Keypad
1
PATA PowerDay

ADE Accenta G3 Specifications

General

Brand	ADE
Model	Accenta G3
Category	Security System
Language	English