How to set the system
When you leave your premises you will need to set (or turn on) the intruder alarm system.
1. Before setting the system you should ensure that
the premises have been completely vacated and
that all doors and windows are closed. Ensure
that pets do not have access to the protected areas
as they can cause a false alarm.
The green Day indicator should be lit.
2.
Enter your code and check
that the system is clear (none of the zone
indicators are lit).
The system will now produce an exit beep tone.
You should leave the premises by the exit route
recommended by your installer. The system will
set when the exit beep tone stops.
3.
The Day indicator will go out. You should wait
until you hear that the exit beep has stopped
before assuming that the system has set.
3
Accenta/Optima G3 intruder system
0 1 2 3
Exit beep
To Next Page
Loading...
Need help?
General
