How to change the Duress code
Your alarm system can have a duress code. The Duress code is used in a hold-up situation where
there is pressure to set or unset the system. The Duress code operates like your normal code but in
addition it will silently send a signal to the Alarm Receiving Centre who will inform the Police. The
duress code can only be changed by the main user. Note the Duress code facility is not applicable to
Optima compact G3 system.
1.
Press and enter your code
. The TA (Tamper)
indicator will light and the Day indicator will go
out to indicate that you are in Programming
mode.
2.
Press to select Duress code programming.
The Zone indicators 1 to 4 will light to prompt
you for a new code.
3. Now enter your new duress code
.
4. If the code is accepted the system will produce a
series of rapid beeps.
If the code is rejected, for example if it is already
in use, the system will produce a flat reject tone.
You must go back to step 2.
5.
Press to exit programming mode. The TA
(Tamper) indicator will go out and the Day
indicator will light.
Example
If you need to change the duress code to 6543, then:
Press .
12
Operating instructions
Prog
0 1 2 3
9
n n n n
Rising beep
To Next Page
Loading...
Need help?
General
