ADE Accenta G3 User Manual

How to view the event log
The event log keeps a memory of the last 8 alarm events.
1.
Press and enter your code .
The TA (Tamper) indicator will light and the Day
indicator will go out to indicate that you are in
Programming mode.
2.
Press . The system will display 8 alarm events
in sequence, with the last (most recent) alarm first.
When 2 or more indicators are lit, the flashing
indicator shows the first alarm, and the steady
indicators show the second and subsequent alarms.
The example here shows an event where Zone 3 was
the first zone in alarm followed by Zones 1 and 2.
3. All 8 alarm events will be displayed in sequence,
with a 5 seconds delay between each event. You can
cause the display to pause by pressing Chime. You
can also display a specific event by pressing its event
number, to .
4.
Press to exit the event log and press again
to exit program mode. The TA (Tamper) indicator
will go out and the Day indicator will light.
13
Accenta/Optima G3 intruder system
Prog
0 1 2 3
Chime
Chime
1 8
Reset Reset
ZONES
Attack
Tamper
Day
1
2
3
4
5
6
7
8
Power
Panel
ZONE
24
56
7
8
3
Remote Keypad
1
PATA PowerDay
ZONES
Attack
Tamper
Day
12345678
Power
Panel
ZONE
24
56
7
8
3
Remote Keypad
1
PATA PowerDay
ZONES
Attack
Tamper
Day
1 2 3 4 5 6 7 8
Power
Panel
ZONE
24
56
7
8
3
Remote Keypad
1
PATA PowerDay

ADE Accenta G3 Specifications

General

Brand	ADE
Model	Accenta G3
Category	Security System
Language	English