(continued)
Testing Your
System
A
1.
2,
TESTING THE SYSTEM
Open and close each protected door and window in turn and listen for the
required sound (3 beeps). The identification of each faulted protection point
should appear on the display.
Walk in front of any interior motion detectors (if used) and listen for the required
sound as movement is detected. The identification of the detector should appear
on the display when it is activated.
Note: Wireless units will send signals out only if they have been inactive for 3
minutes.
3. Follow the manufacturer’s instructions to test ail smoke detectors, to ensure that
all are functioning properly. The identification of each detector should appear on
the display when each is activated.
4. After all protection points have been checked and restored, there should be no
zone identification numbers displayed. If a problem is experienced with any
protection point (no confirming sounds, no dispiay), CALL FOR SERViCE
IMMEDIATELY.
5. Turn off the Test mode by entering the security code and pressing the OFF key.
-25-
To Next Page
Loading...
