18
5-4-4 Specific Memory Channels
This transceiver provides 81 Memory Channels(CALL channel
included).
In addition to serving as a normal Memory Channel, some of the
Memory Channels serve a dual purpose to specify other parameters.
The functions of those Memory Channels are described below.
● Memory Channel 1 is used to store the frequency for the DUAL-
WATCH function.
● Memory Channel 11 is used to store the lower limit for the
Programmable Band Scan function.
● Memory Channel 12 is used to store the upper limit for the
Programmable Band Scan function.
5-4-5 Memory Entry
● Simplex/Normal shift
1. Press the VFO/MV key to select the VFO mode.
2. Select the desired operating frequency, offset, tone, frequency,
etc.(For example 145.500MHz)
3. Press the F key. The F indicator and a memory channel indicator
will light.(For example CH8)
4. Select the desired Memory Channel using the Tuning Control or
microphone UP/DN switches.(For example CH5)
5. Press the MR/M key within 10 seconds of selecting the Memory
Channel. A beep will sound and the F indicator and the
Memory Channel number will turn on and the transceiver will
change into Memory mode.
To Next Page
Loading...
