ADI COMMANDO 246 BM - 3 Accessories; 4 Installation Instruction

6
ACCESSORIES
Unpack your new transceiver carefully, and examine it for visible
damage If the equipment has been damaged in shipment, notify the
transportation company immediately. Save the boxes and packing
material for future shipping.
The following accessories should be included in the box with the
transceiver.
DTMF Microphone
MC147D.......................................................................................1 ea.
or
Dynamic Microphone
(GENERAL market only) MC147..................................................1 ea.
Stacking plate
DC power Cable...........................................................................1 ea.
Fuse..............................................................................................1 ea.
Instruction Manual........................................................................1 ea.
Warranty Card.............................................................................. 1 ea.
INSTALLATION INSTRUCTION
4.1 INSTRUCTION
MOUNTING BRACKET
When installing the transceiver in a vehicle consider the ease of
operation and safety when selecting the location for the mounting
bracket.
1. Install the bracket using the supplied flat washer and self tapping
screws (4 pc s. each).
2. Attach the transceiver loosely using the 4 SEMs screws.
3. Align the grooves in the bracket with the transceiver's screws
(Fig. A ) and slide the transceiver to the rear.
4. Adjust the viewing angle in the bracket to the desired position
(Fig. B).
5. Hold the transceiver in place and tighten the 4 SEMS screws
using the supplied wrench.