Ados A100E - 6.3 Operating parameter configuration

ADOS S.R.L. Buccinasco (MI)
492-MTU10006 Rev. 4 Page 36 of 49
6.3 Operating parameter configuration
6.3.1 Operating parameter selection
Entering the configuration from the configuration level selection menu the instrument prepares to configure
the first parameter and displays the following message:
G R A D
Press the F key to sequentially select all the configurable parameters (after reaching the last one it returns
automatically to the first one).
Pressing the numeric keys directly sets the number of the parameter to be configured.
Press the N/G key to decrease the number of the parameter selected (after reaching the last one it returns
automatically to the first one).
Press the C key to cancel the configuration request and return to the configuration level selection menu.
Press the E key to confirm the selection made and the instrument prepares to configure the parameter
selected: the primary display indicates the value or the code of the parameter and the auxiliary display
flashes to indicate that the instrument is prepared to accept the change to the value of the parameter.