INSTALLATION
17
[5]
For Bio systems, unpack the ultrafilter and screw
it to the holder in front of the system.
Before that, make sure that the yellow O-ring is
inside the holder
[6]
Ultrafilter connected with the system.
After water dispensing put the bell cap
back to the bell
[7]
For HPLC and Trace systems, unpack the 0.22 m
dispense filter and screw it to the holder in front
of the system.
Before that, make sure that the black O-ring is
inside the holder
[8]
0.22 m dispense filter connected with system.
After water dispensing put the bell
cap back to the bell
The microfilter (or ultrafilter) should be rinsed prior to use!
When the tank is full, press the “Dispense” button and rinse the microfilter (or ultrafilter)
with at least 10 liters (or 20 liters respectively) of purified water.
To Next Page
Loading...