INSTALLATION
19
[6]
3. use two 1/4” JG plastic tubes for
connection [pic. 2];
4. connect REC IN on Crystal EX system
[pic. 5] with REC OUT on the tank [pic.
6] (marked with GREEN square);
5. connect REC OUT on Crystal EX system
[pic. 5] with REC IN on the tank [pic. 6]
(marked with BLUE circle)
[7]
Locate 3/8” JG tube with JG elbow adapter
[8]
Connect OVERFLOW port of the tank to the drain
using the 3/8” JG tube with JG elbow adapter
(3/8”).
When installing the tank, connect the
fitting marked “OVERFLOW” to the
drain. Make sure that the drain level is
lower than the “OVERFLOW” fitting level. This
will prevent water leakage in case of tank level
sensor failure.
To Next Page
Loading...