Adrona Q-Front N Trace - Calibration

MAINTENANCE
39
[5]
Place connector tubes in slots.
Make sure that connectors are properly
attached
[6]
Press “Run” button to put the unit in the
“Running” mode
[
7
]
Press “Menu” button and go to
“MaintenancePurge air” to purge air from
polishing cartridge.
Tank should be in “Partial” stage
- Observe for any water leakages from polishing module connections.
- Allow unit to run for 2 hours to decrease TOC level and decrease output conductivity.
Installation and replacement process of polishing and deionization module is identical
Calibration
Adrona water purification systems are already calibrated. Additional calibration is not needed.