Adrona Q-Front N Trace - Module Installation Procedure

INSTALLATION
12
Installation procedure
Open the front door where pre-filter set and polishing module are located.
[1]
Carefully open the front door holding the upper
and lower part with both hands
[2]
Locate the installation slots.
We advise you to do installation in following order:
1 – pre-filter Q module (part no. 10411)
2 – polishing Q module (part no. 10031)
3 – deionization Q module (part no. 10311) is
located on the rear panel
Installation process of pre-filter module,
polishing and deionization module is
identical
[3] [4] [5]
Locate the modules:
1 – pre-filter module is marked with
BLUE sticker;
2 – polishing module is marked
with SILVER sticker
3 – deionization module is marked
with BLUE sticker;