4–1
SECTION 4
Initial Setup
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
In This Section
♦
Programming the Conrol
Panel
♦
6270ADT Initialization
♦
How to Change the ECP
Address
♦
How to Access the Central
Station Screen
♦
6270ADT Setup
♦
Setting Chime Mode On/Off
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Programming the Control Panel
The 6270ADT will not be fully operational unless its address in the
control panel has been enabled for an alpha console, AUI type device,
and assigned to a partition (where applicable). Refer to
“Compatibility” on page 1–2 of this document for the quantity of
6270ADTs that may be used and the required control panel software
revision level.
On residential control panels (Safewatch Pro 3000EN or
equivalent), two 6270ADTs may be used (addresses 1 and 2). These
addresses (in field *189) are enabled by default. If the defaults have
been changed, enable these addresses (in field *189) using an alpha-
keypad and the Data Field Programming procedures located in the
panel Installation and Setup Guide.
On commercial control panels (VISTA-128BPADT, VISTA-
250FBPADT, or equivalent), addresses between 1 through 30 may
be used for the 6270ADT. These addresses in the control panel are
normally not defaulted for AUI type devices. To enable the addresses
you will be using for 6270ADTs, use an alpha-keypad and follow the
procedures for “Device Programming” in your control panel
“Programming Guide.”
To Next Page
Loading...
Need help?
General
