Advanced Diagnostics TCODE PRO - Add Master or Valet Key - Type 2

544
Advanced Diagnostics USA Manual for MVP & TCODE PRO – Copyright 2014 Advanced Diagnostics USA INC.
VEHICLE SELECTION
MITSUBISHI
NISSAN
SUZUKI
> TOYOTA
V.W./AUDI GROUP
VEHICLE SELECTION
> Immobilizer
REMOTE
VEHICLE SELECTION
TYPE 1
> TYPE 2
ECU IDENTIFICATION
TOYOTA/LEXUS TYPE 2
PRESS ENTER KEY
SWITCH IGNITION ON
PRESS ENTER KEY
DIAGNOSTIC MENU
ECU IDENTIFICATION
FAULT CODES
LIVE DATA
ACTUATORS
> SPECIAL FUNCTIONS
DIAGNOSTIC MENU
RESET Immobilizer
> PROGRAM KEY
ERASE KEYS
PROGRAM KEY
SWITCH IGNITION OFF
REMOVE KEY
INSERT KEY
SWITCH IGNITION ON
WITHIN 120 Sec
TIME ELAPSED: 0 S
PRESS ENTER KEY
PROGRAM KEY
SWITCH IGNITION OFF
REMOVE KEY
WITHIN 20 Sec
TIME ELAPSED: 0 S
PRESS ENTER KEY
NOTE: If you do not have an existing Master key, you must use the “Reset Immobilizer” procedure to Reset
the Immobilizer system. A Valet key will not work as a substitute for a Master Key.
PROGRAM KEY
INSERT NEW KEY
LEAVE IGNITION OFF
WITHIN 10 Sec
TIME ELAPSED: 0 S
PRESS ENTER KEY
PROGRAM KEY
PLEASE WAIT
TIME ELAPSED: 2 S
PROGRAM KEY
PROCEDURE COMPLETE
TIME ELAPSED: 59 S
PRESS ENTER KEY
Note: This usually takes about 60 seconds.
If the timer goes past 120 seconds, stop.
The key is most likely now programmed.
Disconnect & try key.
Note: You must remove the Master
key & then press enter.
Note: You must insert the New key
but do not turn it.
Press Enter when done.
Insert a Master key that is already registered into the vehicle. Turn the ignition lock to the “ON”
position. The Security Light must be out when the key is in. Connect and follow screens.
ADD MASTER or VALET KEY - TYPE 2
MVP &
TCODE
TOYOTA
ADVANCED DIAGNOSTICS USA
powered
by
MVP &
TCODE
ADVANCED DIAGNOSTICS USA
powered
by
PRIUS ‘04-’09
MVP &
TCODE
TOYOTA
ADVANCED DIAGNOSTICS USA
powered
by