550
Advanced Diagnostics USA Manual for MVP & TCODE PRO – Copyright 2014 Advanced Diagnostics USA INC.
VEHICLE SELECTION
MITSUBISHI
NISSAN
SUZUKI
> TOYOTA
V.W./AUDI GROUP
VEHICLE SELECTION
> Immobilizer
REMOTE
PROXIMITY
VEHICLE SELECTION
TYPE 1
TYPE 2
TYPE 3
> TYPE 4
ECU IDENTIFICATION
TOYOTA/LEXUS TYPE 4
PRESS ENTER KEY
SWITCH IGNITION ON
PRESS ENTER KEY
DIAGNOSTIC MENU
ECU IDENTIFICATION
FAULT CODES
LIVE DATA
ACTUATORS
> SPECIAL FUNCTIONS
DIAGNOSTIC MENU
> RESET Immobilizer
PROGRAM KEY
ERASE KEYS
RESET ECU
RESET Immobilizer
GAINING ACCESS
TIME REQUIRED 30:00
TIME ELAPSED 0:28
RESET Immobilizer
PROCEDURE COMPLETE
PRESS ENTER KEY
STANDARD RESET Immobilizer - TYPE 4
DIAGNOSTIC MENU
RESET Immobilizer
PROGRAM KEY
ERASE KEYS
> RESET ECU
RESET ECU
PROCEDURE COMPLETE
PRESS ENTER KEY
Now you must
RESET the ECU.
Old way of doing a Type 4 Reset, (use only in rare instances, see note)
NOTE: The quick reset on the previous page can be used 99% of the time and the old method shown
here is almost NEVER needed. However in some rare instances the quick reset may only allow TWO
keys to be programmed. In these cases you can still use the old method with the security delay, after
which 3 or 4 keys can be introduced successfully.
Note: You must remove the Master key & Disconnect the tester at this point.
The Immobilizer system is now Reset. The Security Light should remain steady & illuminated.
The vehicle is now in Auto Learn mode. Auto Learn mode is indicated by the steady illumination of the Security Light. Insert each key
you want to program - but do not turn the key on - only insert and remove after 4 seconds. The vehicle may learn up to 4 keys before
the Auto Learn cycle is shut down.
You can close the cycle early by turning the ignition lock from Off to On and back to Off 6 times, very fast, with a Master key.
Remove the key and re-insert it and the Security should be out when there is a programmed in the ignition.
MVP &
TCODE
TOYOTA
ADVANCED DIAGNOSTICS USA
powered
by
To Next Page
Loading...
