Command Set
4-32 ADAM 4000 Series User's Manual
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Sets the address, input mode, baud rate,
checksum status and/or frequency gate time
for a specified counter/ frequency module
4 168
$AA2 Configuration
Status
Returns configuration parameters from the
specified counter/frequency module
4 170
$AAF Read Firmware
Version
Return firmware version code from the
specified counter/frequency module
4 171
$AAM Read Module Name Return the module name from the specified
counter/frequency module
4 172
$AABS Set Input Signal
Mode
Sets the input signal mode of the specified
counter/frequency module to either non-
isolated or photo-isolated input signals
4 173
$AAB Read Input Signal
Mode
Read the input signal mode of the specified
counter/frequency module.
4 174
#AAN Read Counter or
Frequency Value
Returns the value of counter 0 or counter 1
from a specified counter/ frequency module
in hex format
4 175
ADAM-4080 Command Table
(continued on following page)
To Next Page
Loading...