Advantech Adam-4018 User Manual

Command Set
4-36 ADAM 4000 Series User's Manual
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Sets the address, input mode,
baud rate, checksum status and/or
frequency gate time for a specified
counter/ frequency module
4 168
$AA2 Configuration Status Returns configuration parameters
from the specified
counter/frequency module
4 170
$AAF Read Firmware Version Return firmware version code from
the specified counter/frequency
module
4 171
$AAM Read Module Name Return the module name from the
specified counter/frequency
module
4 172
$AABS Set Input Signal Mode Sets the input signal mode of the
specified counter/frequency
module to either non-isolated or
photo-isolated input signals
4 173
$AAB Read Input Signal Mode Read the input signal mode of the
specified counter/frequency
module.
4 174
#AAN Read Counter or
Frequency Value
Returns the value of counter 0 or
counter 1 from a specified
counter/ frequency module in hex
format
4 175
$AA8V Select LED Data Origin Select whether LED will display
data from the counter/frequency
module directly or from the host
computer
4 176
$AA8 Read LED Data Origin Returns the status of the LED Data
origin. Origin is either direct from
module or from host computer
4 177
$AA9(data) Send Data to LED PC sends data to LED display. This
command is valid only after
selectting to display host
computer data ($AA8V)
4 178
ADAM-4080D Command Table
(continued on following page)

Advantech Adam-4018 Specifications

General

Brand	Advantech
Model	Adam-4018
Category	Other
Language	English