Chapter 4 Command Set 4-61
Example command: $074(cr)
response: >071+5.8222(cr)
The command asks the analog input module at address 07h to
send its analog input data.
The analog input module responds with status = 1, which
means that this is the first time that the data has been sent and
that the data = +5.8222 Volts.
(Configured data format of the analog input module in this case
is engineering units.)
command: $074(cr)
response: >070+5.8222(cr)
The command asks the analog input module at address 07h to
send its analog input data.
The analog input module responds with status = 0, which
means that it has sent the same data at least once before, and
data = +5.8222 Volts. This could indicate that a previous
Synchronized Sampling command was not received!
(Configured data format of the analog input module in this case
is engineering units.)
4011, 4011D, 4012, 4013, 4015,
4016, 4019
To Next Page
Loading...
Need help?
General
