Appendix D Utility Software D-9
Appendix D
NOTE 1.When standalone mode (in Memory Configuration Settings) is
set to "NO" and you want to read data from the data logger, you MUST set
the operation mode to "STOP" before you read data.
NOTE 2.In standalone mode, if an LED light begins to blink once per
second, 15 seconds after power is turned on, this means that the memory is
not working. Turn the power off, then back on, and check the memory.
Data reading
This screen allows users to read data stored in the memory, after the data has
been transferred to the host.
To Next Page
Loading...
Need help?
General
