Command Set
4-10 ADAM 4000 Series User's Manual
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Sets the address, baud rate, data
format, checksum status, and/or
integration time for a specified analog
input module
4-44
#AA Analog Data In Returns the input value from a
specified analog input module in the
currently configured data format
4-52
$AA0 Span Calibration Calibrates an analog input moudle to
correct for gain errors
4-57
$AA1 Offset Calibration Calibrates an analog input moudle to
correct for offset errors
4-58
#** Synchronized
Sampling
Orders all analog input modules to
sample their input values and store
them in special registers
4-59
$AA4 Read Synchronized
Data
Returns the value that was stored in
the specified module’s register after
the #** command
4-60
$AA2 Configuration Status Returns the configuration parameters
for the specified analog input module
4-48
$AAF Read Firware Version Returns the firmware version code
from the specified analog input
module
4-50
$AAM Read Module Name Returns the module name from the
specified analog input module
4-51
ADAM-4013 Command Table
To Next Page
Loading...
Need help?
General
